======================================

TUTORIAL SAMSUNG VIA ODIN

======================================

How to Flash Samsung ROMs via Odin

CRITICAL WARNING:

Before starting the flashing process, your Samsung device MUST have an Unlocked Bootloader (UBL). Flashing a Custom/Bypass ROM with a Locked Bootloader will result in a Hard Brick (dead device). Proceed entirely at your own risk.

Execution Steps:

[1] File Preparation: Extract the downloaded ROM file (.zip or .rar) from Nyubicrew into a folder on your PC. Ensure you have installed the Samsung USB Drivers.

[2] Enter Download Mode: Turn off your Samsung device. Boot into Download Mode (usually by holding Volume Up + Volume Down while plugging the USB cable into the PC).

[3] Execute via Odin: Open the Odin application on your PC. Make sure your device is detected (the ID:COM port should turn blue).

[4] Input ROM Files: Load the extracted files into their respective Odin slots. Load the file starting with BL into the BL slot, AP into AP, CP into CP, and CSC into CSC.

[5] Flashing Process: Click the Start button in Odin and wait until the process is complete and PASS! appears.

[6] Mandatory Wipe Data: When the phone automatically restarts after Odin finishes, IMMEDIATELY press and hold the Volume Up + Power buttons simultaneously to force the device into Recovery Mode.

[7] Factory Reset: Inside Recovery Mode, navigate to Wipe data/factory reset (use volume keys to navigate, power key to select). Confirm the wipe process.

[8] Reboot System: Once the data wipe is complete, select Reboot system now.

[9] Initial Boot: The device will boot up, which may take longer than usual. Wait until you reach the Home Menu.

[10] Finalization: Complete the initial phone setup as usual. Install your preferred FakeGPS application. The device is now ready for operational use.